handsbogan
Programmer
INVALID IE CONTENT! RECIEVED THIS ON Q931E CIRCUIT CALL IS THEN REJECTED.
Has anyone same the same?
Has anyone same the same?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
INVALID IE CONTENT 1
- Thread starter handsbogan
- Start date
- Status
-
1
- #2
PRI or BRI?
Is this a PBX to Public Switch scenario, or PBX to PBX?
If it is PBX to Public Switch the most likely cause would be that the protocol (switch type and variant) are not set correctly on your equipment.
If it is PBX to PBX then the most likely is that one PBX or the other isn't fully comaptible with the relevant standard. But in this case make sure the swithc type is configured correctly too.
Most likely you'll need to capture a Layer 2 + Layer 3 protocol capture and send it to the equipemnt vendor. Post it here and I'll be glad to look it over.
Is this a PBX to Public Switch scenario, or PBX to PBX?
If it is PBX to Public Switch the most likely cause would be that the protocol (switch type and variant) are not set correctly on your equipment.
If it is PBX to PBX then the most likely is that one PBX or the other isn't fully comaptible with the relevant standard. But in this case make sure the swithc type is configured correctly too.
Most likely you'll need to capture a Layer 2 + Layer 3 protocol capture and send it to the equipemnt vendor. Post it here and I'll be glad to look it over.
- Status
Similar threads
- Locked
- Question
- Locked
- Question