This is probably a dumb question - but I'd rather look stupid than make a serious error. I have never installed interstate PRI on a Magix - does it behave exactly the same as a regular PRI? I am specifically worried about assigning outgoing numbers to appear in separate B-channel groups and how outgoing calls will interact with predictive dialers. I did this one other time and I programmed the analog extensions to have an outbound pool "button" so they wouldn't have to dial 9 and am assuming there is no difference but we know what assume means...thanks!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Interstate PRI T1
- Thread starter phonesaz
- Start date
There should be no difference between the two. I would verify the outgoing parameters with the service provider as to digit requirements for DDD, IDDD, and operator calls, if allowed. This way you can adjust the Special Service Table accordingly.
....JIM....
....JIM....
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
