Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Interruption

Status
Not open for further replies.

CCortez

Programmer
Sep 18, 2000
16
BR
I'm a newbie in CBuilder. I'd like to convert a software from DOS to Windows, but it manipulates interruption IRQ5 to obtain data from a prototype board. I don't know how to do this in CBuilder. Somebody may help me, with a sample code?
Thank you.

 
I'm afraid that you under Windows must disregard the interrupts at least if your'e under NT, the DOS version works under Win95 & 98. There is a possibility of making a driver i do believe but i take it that you have to do a polling in a thread and have that thread do some stuff. In the same breath you must be aware that NT does NOT allow direct port access without special driver, these should however be possible to get! Look in the FAQ, there is better information there.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top