Interruped Firmware Download

[dabble]

CS1000M at 7.5
I was in the middle of doing a firmware download to an M3903 set.
I advertenly pulled the jumper off the bix therefore causing the interruped download.
The phone is now pooched.

Is there a way to recover this phone somehow or is it completely broken now.

Thanks.

 

[KCFLHRC]

I think it's trash, seen this before

 

[Romar53]

If the 3903 has a X on the screen, then go into LD 32 and do FLDF using the TN. This happens on my site when the user unpluggs the phone in the middle of a firmware upgrade

 

[dabble]

The display reads "Hwaiting Download..."

So I guess it goes into the recycling bin.

Thanks.

 

[Firebird Scrambler]

This solution is old but might help?.

Problem Text:
M3905 sets dead and displaying 'WAITING DOWNLOAD' and do not complete the
download.

Setup and actions performed to cause the problem:
upgraded to 25.40. and scheduled downloads in overlay 97
executed download in overlay 32. and an attempted download ensued where 24
sets out of around 250 failed.

Expected Results:
Sets should download and recover.

Actual Results:
sets display waiting download with no progress.
Here are 2 different sets w/the same problem, also, one see's the firmware
version as 78, the other see's it as 00 !!
Problem Text:
When downloading Taurus sets, occassionally the download will hang for extended periods
(up to 1 hour) and produce error message IOD051.

Setup and actions performed to cause the problem:
upgraded to 25.40. and scheduled downloads in overlay 97
executed download in overlay 32.


Expected Results:
Sets should download without pause or IOD051.

Actual Results:
Download pauses twice during the night producing IOD051. After pause,
the download resumes OK.

############################################################################

LD 32 SUSP, and FDLC to entered to stop the download
- The sets must be given the FDLF L S C U to recover


All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.