Internet access for remote sites

[12122053]

I have a cisco lab at my home. For my internet access im using a dsl through a 2611 router. I setup to 2 remote sites via back to back over frame-relay. How do i setup them up for internet access from my 2611 router. The remote sites can ping the inside ethernet interface on the 2611. Do i need to setup NAT to the remote sites or just the 2611 will do? Thanks who help.

 

[sobak]

What IP Address scheme are you using, Public or Private? you say two remote sites, how many total routers do you have. From your descripton I understand three, am I correct?

 

[12122053]

Private addressing and 3 routers. The only public address i have is to the DSL line, thanks.

 

[sobak]

Run NAT at your 2611 to your external ethernet port. On your serial and LAN ethernet port place ip nat inside. On your WAN interface use ip nat outside

Hope this answers your question, since private ip addressing does not route over the internet you are forced to use NAT on your 2611.

david e