Inter Digit Response Time

[Wiremonkey01]

Can anyone tell me where to locate the Inter Digit Response Time setting on a 61c with Succession 3.0 software?

We are having trouble with Alfa pagers being sent call back numbers via internal stations. The pager service is trying to point the finger back at our system saying the caller may be dialing faster then the system can accommodate and may be dropping part of the digit string of the call back number.

Thanks

Russell

 

[ss341]

Make sure your tones you are sending are long enough.
Config record/PARM/DTRB should be 100. if not change it.
LD 17
REQ CHG
TYPE CFN
PARM YES
- DTRB 100 Digitone burst time in milliseconds.

Inter digit timing is in LD 56
-ID1 256-(768) - 1024 Inter-Digit 1
-ID2 256-(512) - 1024 Inter-Digit 2
-IDD 256-1024 Inter-Digit DTMF

But I wouldn't change the default.
I've run into the pager service NOT recognizing the combination of the two tones that make up each Digitone signal.