Instruction guide somewhere for opening a CR from Visual Basic???

[Paladyr]

Can anyone point me to an instruction guide for opening a Crystal report (8.5) from Visual Basic (6.0)?? I'm sure I could figure it out but I want to make sure I am doing it correctly as well as the best possible way. Thanks!

 

[Paladyr]

D'uh, just found this:

http://www.tek-tips.com/faqs.cfm?spid=766&sfid=540&CFID=67467477&CFTOKEN=45421034

NM!!!

 

[dgillz]

Try Ken Hamady's quick reference guide. It will get you started, only $14 and no I do not get a commission for pumping this. Software Support for Macola, Crystal Reports and Goldmine
dgilsdorf@mchsi.com

 

[Paladyr]

Okay, i read through the FAQ but I am still not sure how to do it. I already have the tables setup in the report, so all I need to do is set the location of the database inside the report and then "verify" the database to update it with the new information. Can someone tell me how to do this? Thanks!

 

[Paladyr]

Anyone??????

Basically i have a report that draws info from two tables. I have already manually pointed it to the correct database however I want to programmatically specify where the database is each time the report is run. Can someone please help or point me to a more thorough FAQ (the one I saw never explained how to open a specific table, nor did it explain how all the variables were defined). Thanks.