Installing new PRI

[ronwmon]

Hello,

We have a Lucent G-3 V9.5 and we are trying to add a PRI circuit.

I have set up the DS1, signal group and trunk group. Currently I have just 3 members in the trunk group, I will add the rest once it is working correctly.

When I do status tru 8 it shows all 3 members “in-service idle.”

The trunk group is set up for dial access with a TAC of 708. When I dial 708 I get an “All circuits are busy” message.

Our circuit provider Time Warner sent a tech to our location yesterday. He hooked up a device to the circuit and was able to make and receive a call on the circuit.

I would appreciate any assistance you may be able to provide.

Ron--

 

[AvayaTier3]

You cannot TAC dial isdn trunks to a network provider

A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"
Avaya. Too little or no help? Expensive?
For FAST switch support at bargain rates, give bsh a call.

bsh

40 years Bell, AT&T, Lucent, Avaya
Tier 3 for 30 years and counting
[URL unfurl="true"]http://bshtele.com[/url]

 

[wellco9530]

Like "bsh" said you can't do it that way....Only way to test them quick is to do it out of hours.....Put your new trunks in another trunk group, change your route pattern for the call you want to test and put your new trunk group in that route pattern on top...and make a call...status your station to make sure your on the proper trunk and you should be good to go...
Good Luck...

...bob...