I am having difficulty installing FA331 on SCO openserver 8
The custom command is different from the way it is described in the help file on the FA311 diskette. Below is what I get when I try it.
This is what is happening.
I start the program called "custom"
it brings up a menu with 1 item in it. "1. Add a Supported Product"
That is the only option other than "q" to quit.
I enter "1"
you get
Please enter media type:
1. Floppy
2. Tape
3. Disk Image
Select an option or enter "q" to quit
It doesn't matter which one I try 1 or 3. I get the same thing.
It prompts you for the diskette.
after that you get a error that read as follows:
UX: tar: ERROR: Directory checksum error
ERROR extraction of ./tmp/parms failed: try again? (Y/N)
you get that same error when you use "3" for disk image..
If you have had this, or a similar problem, please tell me what you did to fix it. Thank you very much.
Weirdo
The custom command is different from the way it is described in the help file on the FA311 diskette. Below is what I get when I try it.
This is what is happening.
I start the program called "custom"
it brings up a menu with 1 item in it. "1. Add a Supported Product"
That is the only option other than "q" to quit.
I enter "1"
you get
Please enter media type:
1. Floppy
2. Tape
3. Disk Image
Select an option or enter "q" to quit
It doesn't matter which one I try 1 or 3. I get the same thing.
It prompts you for the diskette.
after that you get a error that read as follows:
UX: tar: ERROR: Directory checksum error
ERROR extraction of ./tmp/parms failed: try again? (Y/N)
you get that same error when you use "3" for disk image..
If you have had this, or a similar problem, please tell me what you did to fix it. Thank you very much.
Weirdo