Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

install programme

Status
Not open for further replies.

ascikey

Programmer
Feb 18, 2004
127
GB
Please help new to Linux but trying
I have a tar file in the directory “/home/tony/overnet” that I want to uncompress and then install into a folder called “/home/tony/overnet/overnetinstall” the tar file is called overnet0.51.2.tar.gz.
Could somebody please tell me how to do this
Thanks
 
[tt]tar zxvf overnet0.51.2.tar.gz[/tt]
then cd to the new directory, probably [tt]./configure && make[/tt]

----
JBR
 
thanks yep i see i didn't put the f in the zxvf and i used xz .It just hung prob as is it couldnt make the new dir
[hammer]
 
Ok done that but when i ./configure output says no such file or directory so i try make and output says
"make *** no target specified and no make file found".
The files that came from the tar file are: contact.dat, overnet0.51.2 and readme. the readme has no install info
any ideas would be appreciated.
 
is 'overnet0.51.2' a directory? probably 'cd overnet0.51.2', then './configure && make'. the README has nothing about installation?

----
JBR
 
hi flugh, thanks for your reply again.
is 'overnet0.51.2' a directory?
'overnet0.51.2' is not a directory but not sure what it is.
i am on "fedora core 1" and the icon is like a text file with a rocket ship in the corner. Hang on its a binary just gone to properties and typed ./overnet0.51.2 after that it started. i actually already tried that but forgot the ./ and hence got "command not found" which i wrongly thought must mean that it wasnt a programme

sorry for wasting your time i will try this method next time

thx again
 
ack, didn't realize you were trying to do this via some filemanager. In that case, I applaude you for being able to install it at all. Me, I'm handicapped by having to have a commandline available to do stuff like that ;-)

If you have a doubt about what a file is, try the 'file' command. It's a real handy tool. Also, in case you don't already have it set up, do an: alias ls='ls --color' to get colorized ls output. Usually blue is a directory, green is an executable file. You may even run across a horrible blinking red file that is a broken symlink (been a while, think it was Redhat back in the 7.x days?).

Stacker 2: The Breakfast of Champions!

----
JBR
 
the color alias works well thancks for the tip

:)
 
the color alias works well thanks for the tip

:)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top