Install new 11.0 FP4 ServerEdition

[Albus2]

Did you allready install a ServerEdition with ABE_11_0_4000_74_OVF10.ova

Using WebManager, I can't get out of the wizard. It goes directly into Offline-Mode and then to the 'VoIP' tile, skipping 'System'.
Even If I change something to be able to save and reboot, it is coming back with the same as before...

 

[TheSmash]

What happens if you click the "Save to IP Office" in the yellow banner?

ACSS (SME)

 

[Albus2]

They must have introduced a few bugs, hence it's not Service pack, but FEATURE pack 4....

I got it working, following this steps:

- Deploy OVA as usual
- browse to

https://192.168.42.1:7071

and change what you need to.
- use AdminLite and open the new system. The Initial-Configuration-Utility will open.

- Notice, what the changed: There is a field for a default extension password.
* Normaly if there is a 'click-to-reveal' you only have to enter the secret once and not twice...
* It will only let me save, when this password is at least 9 (nine) digits long. But you can change it later to 8 digits, using WebManager and 'Initial Configuration' in the ///-Menu...

- Finally it will ask to reboot.
- Use either AdminLite or WebManager to set licence mode for all nodes.
- Use AdminLite to set Security properly.


- If setting up a Anywhere-Demo, instead of going a second time through the ICU, it only asks to change the Administrator password. (OK, but then everything else is at default.)
- Therefore, use AdminLite to set Security properly.
* Forced to change default password, but even if the System password is changed, it still complains about being on default - and does not let me save anything!
!update: You can use AdminLite to reset the security. Then, its possible to change and save all accounts and passwords.

 

[Albus2]

@TheSmash

1 Nothing, unless anything is changed. In this case I had to change someting in 'VoIP'.
2 The a reboot ia offered and effectively it reboots.
3 After login again, it proceeds a point '1'

They did not test this OVA...

 

[Albus2]

Updateed my post, to add how to work around the issue with not being able to save security.