insert # as first and last digit.

[fcepeda]

hello:

Does any body known how to insert # as first an last digit of a dialed telephone number in a Definity G3siV4 ?

I using a cellsocket with a celluar service that uses #99-9999-9999# to dial, at this moment I can put # as first digit using "inserted digits" in "change route-pattern 99" command, but i don´t know how to insert as last digit too.

thanks,
Francisco Cepeda
Monterrey, Mexico.

 

[Ronster]

Can't you just dial the last #?
Are you sure you need the last #?

I'm in the UK, if I dial a # at the end of a dial string it just tells the switch/network I'm finished dialling. If I leave the # off it waits for the switch timeout before the call is connected to the network.

Ronster

 

[telcoguy]

Use ARS digit conversion,
and insert the digits there
enter the string, if needed with wildcards, and then replace it with #<string>#
This inserts the #'s when conditions are met
This works for any type of carrier pre-select situation.


Hope this helps


Rob