telepath9465
IS-IT--Management
Hi All, this is a new Call Pilot 4.0 install. This is the first time I've used a new transceiver on the PBX side, usually we use the Centrecom 210TS. This new transceiver is integrated male amphenol to RJ45 all in one piece. I like the design however I'm receiving errors. I was receiving input and output errors. I changed this new tranceiver to half-duplex which corrected the output errors, but continuing to receive input errors. It isn't too many errors, may not impede service. ELNK ENABLED
Ethernet (qu unit number 0):
Host: CPLOT
Internet address: 10.1.1.1
Broadcast address: 10.1.1.255
Ethernet address: 00:90:cf:06:83:dc
Netmask: 0xff000000 ; Subnetmask: 0xffffff00
180 packets received; 272 packets sent
8 input errors; 0 output errors
0 collisions
.
Ethernet (qu unit number 0):
Host: CPLOT
Internet address: 10.1.1.1
Broadcast address: 10.1.1.255
Ethernet address: 00:90:cf:06:83:dc
Netmask: 0xff000000 ; Subnetmask: 0xffffff00
180 packets received; 272 packets sent
8 input errors; 0 output errors
0 collisions
.
