Currently, I am facing problem doing call transfer using QSIG in MD110. I understand that if I need to do "call transfer by join" in MD110 required Manufacturer Specific Information to be included in my IE message before I send it over to MD110 from my application. Is there anyone can help me by providing the IE spec needed to do this? I heard that MD110 IE is using ASB501 format. Is this true? and where can I get the spec for this?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
initiate call transfer using IE in QSIG
- Thread starter Q6
- Start date
jackdaniels1955
Technical User
Hi Q6,
Do you know what software level you are at on the MD?? Some of the features are becoming available as an "open standard" ISO/ECMA however I don`t think Transfer has made it yet. Therefore I expect that the Q sig transfer request will go as UUI over Q sig.It looks as if the UUI can be transported in the GFP or out of GFP, do you know which method you are using? What is your call flow scenario? best I could come up with is maybe a protocol trace.
Do you know what software level you are at on the MD?? Some of the features are becoming available as an "open standard" ISO/ECMA however I don`t think Transfer has made it yet. Therefore I expect that the Q sig transfer request will go as UUI over Q sig.It looks as if the UUI can be transported in the GFP or out of GFP, do you know which method you are using? What is your call flow scenario? best I could come up with is maybe a protocol trace.
- Status
Similar threads
- Locked
- Question
- Locked
- Question