Infopath Revisited

[jgilbert]

Seems I am having problems with InfoPath again. Earlier I had designed a form, and had nowhere to set the page margins within the design screen. I reinstalled Service Pack 2, and was finally given the page setup option in View Manager.

I designed a form on my computer with 0.2" margins all-around. This is a necessity as I need the form to fit on one page. On MY computer, the form looks perfect. I published and saved the form with these margins. If I fill out a form on MY computer, it works fine.

I copied to template to another computer. On the OTHER computer, I check the view manager and the page margins are set to 0.2". However, when I do a print preview from design mode, the margins are incorrect. Also, if I try to fill out the form, the margins are incorrect. If I look at page setup in view manager the margins show 0.2", but if I look at page setup in the fill-out mode, the margins are set back to .75".

I have no idea what's causing the problem. I am brand new to InfoPath. It seems to be a very "touchy" program, but I really like it. On MY computer, I published the file to a shared drive. From the OTHER computer, I pulled it off the network drive and saved it onto the local documents folder.

Any help would be appreciated.

Thanks,

Joe