Ind Trunk Select question

[phonetech1]

Hi All!
I am new to our MD110 BC12 and I am trying to figure out how to test my trunks. I've done some searching thru the old posts and there was a good description of a dial string to test a trunk. However I can't figure out what is the SC code for the ind. trunk select. I try ty dial *0* but I get a vacant number message. I don't have an operator console, so I am trying to test from the DBC 203 phone.

Thanks

 

[whosrdaddy]

Hi,

first of all you need to know what your trunk numbers are for the route you want to test:

ROEDP:ROU=X,TRU=ALL;

then to test a trunk in this route all you have to do is :

*0*LTT#ROUDESTxxxx

where L = lim number where trunks are
TT = 2 digit trunk number (so trunk 1 is formatted as 01)
ROUDEST = destination to the route you want to test
xxx= rest of the number

so an example would be :

I want to test trunk 9 of route 60 (which resides in LIM2) which has accescode 0 to dial out :

*0*209#0xxxx

Cheers,
Daddy

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[phonetech1]

I just tried that, but as soon as I dial *0* I get the reorder tone and my display shows: Vacant Number!

 

[whosrdaddy]

what is the KSCAP of the phone on which you're trying to do this??

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[phonetech1]

Here it is:

<kscap:dir=1019;
KEY SYSTEM CATEGORY PRINT

DIR TRAF SERV CDIV ROC ITYPE TRM ADC LANE

1019 00050515 0202120100 001151000 013001 20 0 00000000000000 F

END


Thanks

 

[VMPOP]

no, you need to know your dest code , don't put the zero try printing this before

RODDPEST=ALL;

ROU=? DEST=?

when you get know your dest code and which trunks are in which route you will apply the SC correctly

East Or West Google Is The Best