Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Increase Steering Codes Error ESN0138 1

Status
Not open for further replies.

havertyj

IS-IT--Management
Jan 27, 2014
35
US
I need to add additional steering codes into our Nortel PBX as we move to a new phone system. I appear to have run out of steering codes. How do I add more? I am doing the following steps:

>ld 87
ESN000

MEM AVAIL: (U/P): 46140405 USED U P: 5093570 396102 TOT: 51630077
DISK SPACE NEEDED: 517 KBYTES
REQ new
CUST 0
FEAT cdp
TYPE dsc
DSC 1964

ESN138

>err esn138
>

ESN0138
Number of steering codes exceeds maximum number of steering codes
(MXSC) defined.

Severity: Info

It appears we have about 800 of these steering codes currently. How do I increase this number so more can be entered?

Thank you!

John
 
LD 86

REQ: CHG
CUST: 0
TYPE: ESN
enter down to CDP
CDP: YES
MXSC 0-32000 enter in what you need.

Hope this helps.

John Anaya
Amdocs Inc.
ACSS/ACIS - CS1000 Rls 7.5/Call Pilot 5
ACSS/ACIS - SME - IP Office 8.0
APSS/APDS - Avaya UC Services

Public Profile
 
Joe, thanks for the response. I am not sure what that would be.

John, I get the following when trying those commands:

>ld 86
ESN000

MEM AVAIL: (U/P): 46140405 USED U P: 5093570 396102 TOT: 51630077
DISK SPACE NEEDED: 517 KBYTES
REQ chg
CUST 0
FEAT

I do not see the option of TYPE. FEAT comes up next and does not allow me to go past it.

John
 
Feat...ESN
>LD 86
ESN000

MEM AVAIL: (U/P): 896789 USED U P: 459610 118160 TOT: 1474559
DISK RECS AVAIL: 371
REQ CHG
CUST 0
FEAT ESN
MXLC
MXSD
MXIX
MXDM
MXRL
MXFC
MXFS
CDP
MXSC 3000 ############ Increase to 3000 CDP codes.
NCDP
AC1
AC2
DLTN
ERWT
ERDT
TODS
RTCL
NMAP
ETOD
TGAR
 
LittleMaster,

Thank you! That did the trick! I increased to 850 to see if I could add more and it is working again.

I appreciate the help!

John
 
pink for keeping me straight, been a long time since working on these.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top