incorrect of a Lim from a system.

[hughiepal]

Hi --- My Problem - I maintain a 15 Lim system BC9. One remote lim (call it X) was removed from the system by an outside company. This was not done properly, PRINT commands did not work. eg EXDDP:dir=all; resulted in wait wait wait COMMAND LOST. Other print commands resulted in "LIM X IS BLOCKED". The outside company came back with a dummy lim to simulate LIM X, but this did not work. They recommended that an upgrade to BC 12 would solve the problem. Will it?? I reckon PCregen requires printouts in the process uf upgrading. Can the system be cleaned up using SACOC commands? Any ideas out there?
Cheers

 

[TRIDENT100]

The job from the "outside company" is not done properly!!!. They should take the cost for upgrading. BC12 will solve this problem, but also a INL and BC9 will solve the problem.

SACOC may work, but you must know what you are doing!!

/*Trident*/

 

[himdp]

Upgrade or INL of the system will be a problem! If printouts do not work, pc-regen will not be able to extract data to reconfigure the new system. You need to get the temporary LIM back, then reload from a disk with the original configuration which has LIM x on it. Then LIM x must be removed again...this time properly

Removing data by SACOS is a lengthy and expensive business, unless your "ouside company" can do it free of charge, then it is just lengthy!

Himdp.