Incommings calls on S bus type BRI

[T8keiteasy]

Hi,

I've connected visioconference to S bus type bri access (quad bri embedded on 3300 MX v7.1).

Outgoing calls work fine;

How is it possible to configure DDI numbers so the site can be called to ?

Thanks for the tip

Now, it's about French users too !!!

 

[ianuk1974]

Hello There,

Its a bit of a pioan in the bum this 1.

the last time i did was a few releases back and dont suppose it has changed.

you need to create a valid number in the system of your DDI normally via ARS. then in the non dial in trunk fiekld of the tru ser ass assign this num,ber and away you go.

it ccan take a little playing around to get it to work but it does.

Ian

 

[Mitelpassion]

just setup your s bus trunks in a trunk group..in your ars add your did if you have, and point it to a route that references your bri trunk group

have done this a few times and works 100%

 

[T8keiteasy]

Thanks guys...

It works out perfectly...

Since I've posted the question, I had to S bus connect :

Visio, fax system and GSM solution

Thank you

Now, it's about French users too !!!