In Maintenance

[HUCHIMAMA]

Ok,

I have an 0x32 with 4.1 That when it boots up it says it's in maintenance. I am assuming it is because it no longer has the original cards in it. I do not have access to the original configuration on the KSU.

Since the KSU boots in maintenance, no passwords will work. "startup" or "config"

Do any of you folks no of a way to get this cabinet back to default.

kgrant

 

[hawks]

If you can put the cards back in then do a START UP and while the display reads APPLYING TEMPLATE remove power. Then you can take the cards out and you should be able to come as normal.

 

[NTL555]

Just select cold restart on set 221. It'll eventually revert back once you press cold reset.

Nam555

 

[exsmogger]

IF there is a 6-port fiber card in the system, power down, pull the 6-port, then power on. The system should come up in default condition.

Brian Cox

http://www.jandjcommunications.com

 

[galfaro]

I had this problem the other day, bad KSU.
Had to replace.
Gabriel

 

[BagsNYC]

I would be leaning towards hardware change not done properly.

The secret of Joy in work is contained in one word- excellence- To know how to do something well is to enjoy it..

 

[scanjet]

if you have r-1 t-1 software you can default the syatem in a short amount of time then install your 4.1 software works every time for me