image Bcm 3.5

[stevomorrison]

I am doing an upgrade tomorrow from BCM 3.5 to 3.6 to 4.0. I have the bit tool in case of problems but i don't have a 3.5 software disk or am not sure if the bit tool can even image a 3.5 drive.If anyone has info on this or any other problems they encountered in a similar upgrade let me know. Thanx

 

[steeef]

when using BIT you will loose configuration. you should use the 4.0 image, so you won't need to upgrade.

 

[stevomorrison]

I need the image incase of a failure durring the 3.5 to 3.6 upgrade. I would need to reimage the hard drive to 3.5 to restore the backup.