If my system version is SP: 30nCG20 NAT 1

[sergio512k]

If my system version is SP: 30nCG20 NAT, what system Do I have installed? and how do I know how many extensions, lines and what type of lines do I have ?

I know how to access to administration but i do not understand this.

Thanks,

 

[westcoaster]

You have a Modular ICS system, software release R1T1 (release 1 "T1&quot software version G20.
Rough translation... You have one of the very early release of the mod ics... The base system comes configured for 8 co lines by 32 sets. The system is capable of handling two T1 service (not pri) as a result your lines are numbered from 1-4 then 25-28 for a total of eight or, 1-24 for the first dti card and 25-48 for the second.
With your system being "modular" you are able to install both trunk modules and station modules in any combination. Your system supports two types of expansion card. A two port and a six port. further more the expansion card can be either copper or fibre (a copper expansion card is rare but possible) the trunk module is able to support 3 cards (4 lines each) for a total of 12 lines each. There are a variety of line card types that are available (DID, E&M 2 lines,and loop). The station modules are 16 ports each.
As a result I am unable to tell you exactly what you have.

 

[MarvO1]

Westcoaster, that answer was so pretty. You get a star for that one.

MarvO said it

 

[westcoaster]

I really wanted a GOLD star though...

 

[MarvO1]

You have been looking at too many cross-connects. You're going color blind. It is gold. also, too many beers will make it look pinkish.

MarvO said it

 

[westcoaster]

I think it was too many beers...
The star still dosn't look GOLD though...

 

[jerryreeve]

ok how about STAR

JerryReeve
Communications Systems Int'l
com-sys.com

 

[westcoaster]

It's just not the same...

(arms crossed, Bottom lip stuck out, and sitting in a corner glowering at the world, sulking)