IDR inaccessible boot dev on dl360 g2

[fthomas1973]

I am currently test restoring a compaq dl360 with a raid 1+0 config. I have used the smart start to setup the partitions and then used the IDR boot cd to restore the server. Everything went relatively fine until the final reboot. I had restored the system state and c drive. Now I get an inaccesible boot device. I know this isn't a dynamic disk issue, although I am getting the same error as the veritas KB article for it, the disk config is basic. I did not have to load drivers for the controller during the initial setup..could this be a driver issue? Or could this be a boot.ini issue...if I have the compaq EISA partition and a C logical drive how should my boot.ini statement read?

Thanks
Frank

 

[rihu]

hi man !! we did have the same problem couples a week ago
what we did ,we restarted the the server in Safe mode ,and restarted again,,then we tested i a couple of time (reboots)
and the problems was gone..please let me know how u fixit

regards
techfreak