IDC and CTD

[rwicks]

On my Meridian we allow users with CTD class of service to dial an access code "XX" and then dial a 5 digit extension. When I built IDC data in LD 49 all CTD uers could no longer dial digits after the access code. How can I fix this issue, without removing the IDC data table?

 

[bigindian65]

did the ld 49 addition affect which RLI these users accessed?

Mato' Was'aka

 

[rwicks]

It stopped the CTD users from dialing anything that was accessable using the ACOD, such as Pag and calling a remote site.

Before
Calling PBX B from A, PBXDialTone+ACOD+5 DIGITEXTENSION = Completed call

After
Calling PBX B from A, PBXDialTone+ACOD after pressing the next digit we get reorder.

 

[GHTROUT]

CLS CTD is identical to TLD if an ACCD is dialed. CTD is identical to UNR if BARS AC1 or AC2 is dialed.

So, you cant dial ACCD+1... or ACCD+0... from a CTD phone.


~~~
[small]GHTROUT.com | Get the Input/Output Manuals | Tek-Tips FAQs | Recent Replies[/small]

 

[GHTROUT]

I guess a solution is in order - this may work.

Toggle the MANO prompt value in the Route Data Blocks (for those routes that users dial the ACCD)


~~~
[small]GHTROUT.com | Get the Input/Output Manuals | Tek-Tips FAQs | Recent Replies[/small]

 

[nrsman]

When you set up idc did you set FCR data also ?
That will restrict you to dial access codes with a ctd class of service.
Try in ld 49

new
fcr
deny nothing.



****