IBM 4560SLX Tape Library and BE Configuration Help Needed

[jonjones88]

I hope some of you guys have some experience with these awesome (read with MUCH sarc) IBM 4560 Tape Libraries and BE. I have a couple questions:
1. We use SDLT Tapes. Is there a way to configure either the tape library or BE to see the tapes as SDLT by default. They usually just show up as DLT.

2. I have one stack of 4 units linked together that when I try to configure the network parameter, it says it cannot obtain the configuration from the router. I cannot even get to where you can set the ip. Bad router?

Thanks if anyone can help!!!!

 

[jonjones88]

I actually fixed issue 2. Got a new router and it now works fine. But I could still use some info on issue 1. Thanks.