I2033 stuck on Loading: How to default

[my4x4awd]

I have a I2033 that boots right to this message and all three leds are lit. i think this happened since it "might" have been S10 and someone tried to go directly to S74.

LOADING:
Loading boot parameters...
Installing bootrom

and recycles.

I can't get into setup to load firmware, since no Nortel screen and it won't respond anyway. So is there a way to default the set by holding a key while powering it up...so it will load up the default paramenters.

 

[Hairball1]

You might try disconnecting it from power and or POE cable.
Plug it in, as soon as any lamps come on, rake your finger across the softkeys from left to right?
I really know little about the I2003 ( it may not even have any softkeys, but know this works on some other Nortel IP sets.
Good luck.