I need Make and other program for Aix system for install Oracle

[Guest_imported]

I have two Rs6000 installed, the first a Power 570 (with Base operating system and Base Development Libraries ,Diagnostics in English version 4.3.1) I have the stacked medias(two in 8mm tape, and four in 4mm tape) , but after the install i cannot read them
The second a PowerPc c10 (whit all the software installed version 3.2 in Spanish), but the media whith this version are losts.
Is possible try to install the 3.2 version from the second Rs6000???
Thank a lot

Francesco

 

[shiraz]

hi
Run lppchk -v / lppchk -c to check o.s filesets consistency.
Reinstall any broken filesets.

Regds

Shiraz

 

[shiraz]

hi
ooops..infact my first reply goes for wrong question...
As far as your question is concerned you can use NIM for aix installation
over netwrok....perfectly yes when no difference exist in BOS.
In your case difference in BOS may cause a problem....b/c as per my
knowledge only maintainence level upgradation / fixes aplication/same o.s
level installation can be done with NIM.

regds

Shiraz