I have event messages coming up that I can't find?!

[steveebc]

I have a PRI using 6.0 s.w. I keep getting these alarm messages. I can not seem to find them. What do they mean?
Alarm 75 keeps coming up then these other codes pop up.
I know that Alarm 75 ISDN connection issue. Carrier has been running for two weeks w/ no problems. All protocol checks out good.
Thank you


EVT904-010D0002 (S3)
EVT372-00 (S2)
EVT325-00

 

[lugerlover]

first off 6.0 and pri is a bad match

Alarm code: 75
Reset:
No

Description:
Clocking for PRI/BRI Lines is no longer synchronized with the network connection.

Action:
The digital link has been disconnected. Check the connection to your ISDN service provider.

 

[phoneguy427]

I had this before, the cable between the D mark and the telco CSU was only a quad. Replaced it with a new cat 5 and there were no more alarm 75's.

 

[Phonehed]

The correct remedy is to upgrade to 6.1 release 3 or higher.

Anyone running MICS software lower than that with PRI should upgrade immediately whether they are having problems or not.

Trouble shooting any MICS/PRI problems with software that Nortel has already deemed inadequate is a total waste of time!

Phonehed in Dallas