AlaskanTech
Technical User
I can make out going calls, but incoming calls just keep ringing.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
I can make out going calls but incomming calls just keep ringing.
- Thread starter AlaskanTech
- Start date
- Status
- Thread starter
- #2
AlaskanTech
Technical User
so it is my main number that will not pick up outside calls
is it over PRI, if so turn on DCH MON in LD 96, look for incoming setup message, from that you can get the TN of the incoming trunk.
To take a look where it is ringing
LD 80
. trad <trunk TN>
To look at config
LD 20 - Print the trunk TN to get the route and member
LD 21 - Print the RDB of the route to get the IDC table
LD 49 - Print the IDC to see where it is going
Hint, often you may not be looking at all the incoming digits, you usually look at the last few controlled by the length of LDN 0 (Print the LDN_DATA in LD 21), so say LDN0 is 1234 then you would be routing in the IDC table based on the last 4 digits
To take a look where it is ringing
LD 80
. trad <trunk TN>
To look at config
LD 20 - Print the trunk TN to get the route and member
LD 21 - Print the RDB of the route to get the IDC table
LD 49 - Print the IDC to see where it is going
Hint, often you may not be looking at all the incoming digits, you usually look at the last few controlled by the length of LDN 0 (Print the LDN_DATA in LD 21), so say LDN0 is 1234 then you would be routing in the IDC table based on the last 4 digits
- Status
Similar threads
- Locked
- Question
