I am using QMF to extract data from DB2 (in MVS) and I am trying to create a procedure with logic using REXX.<br>
I would like to access a sequentialdataset. Is it possible to use the command EXECIO here ? If not , could somebody suggest waht I should do ?
I have unloaded data from DB2 Tables and then used Rexx EXECIO to read the Sequential Dataset produced by <br>
the unload. I found unload easier to work with as<br>
I did not have any column headings,etc... to deal<br>
with.
I have been able to successfully use EXECIO to access a sequential dataset in a PROC. I had to prefix the statement with ADDRESS TSO to make it work.<br>
<br>
I preferred to extract via SELECT statement and just used a form to restructure the output since it is more flexible. I was able to get rid of the headings through the form.<br>
<br>
Thanks illinoisdb2user for the reply.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.