Hello everyone. I am currently trying to get our mitsubishi laser machine to work with NCNetLite 4.1 to do CNC transfers. We currently have the machine working with hyperterminal, but want to switch to the same program (NCNetLite) throughout the shop. Since we are currently transfering data, the cable and other hardware is fine, so it must be the settings. The controller is a LC10BV, and the settings on hyperterminal are as follows.
Connect To Tab
Connect Using COM1
Configure Button
Bits per Second: 9600
Data Bits: 7
Parity: Even
Stop Bits: 2
Flow Control: Xon/Xoff
Under the settings tab
Function,arrow, and ctrl keys act as terminal Keys
Backspace sends ctrl+H
emulation: ansi
Telnet terminal ID ANSI
Backscroll buffer lines: 500
Input Translation button
Select host system encoding method: Shift-JIS
ASCII Setup
send line ends with line feeds: unchecked
echo typed characters locally: unchecked
line delay: 0ms
Character delay: 0ms
append line feeds to incoming line ends: unchecked
force incoming data to 7-bit ASCII: unchecked
wrap lines that exceed terminal width: checked
If there is any other information you need to help me, please le me know.
Thank you in advance
Connect To Tab
Connect Using COM1
Configure Button
Bits per Second: 9600
Data Bits: 7
Parity: Even
Stop Bits: 2
Flow Control: Xon/Xoff
Under the settings tab
Function,arrow, and ctrl keys act as terminal Keys
Backspace sends ctrl+H
emulation: ansi
Telnet terminal ID ANSI
Backscroll buffer lines: 500
Input Translation button
Select host system encoding method: Shift-JIS
ASCII Setup
send line ends with line feeds: unchecked
echo typed characters locally: unchecked
line delay: 0ms
Character delay: 0ms
append line feeds to incoming line ends: unchecked
force incoming data to 7-bit ASCII: unchecked
wrap lines that exceed terminal width: checked
If there is any other information you need to help me, please le me know.
Thank you in advance