Hyperterm connection to SunFire V120 1

[zach99]

I am trying to connect an Laptop using Hyperterm with a Cisco console cable to a SunFire V120 but no joy!!

I have tried several configurations, speed, parity, stop bit.

Where am I going wrong.

 

[cndcadams]

zack99

pinouts needed for v120;

Machine Sun serial DB25 Machine DB9 adapter
RJ45 RS-232 adapter RJ45 RS-232 Pin
Pin part # 530-2889-01 Pin part # 530-3100-xx
1 (RTS) blue — 5 (CTS) 1 (RTS) blue — 8 (CTS)
2 (DTR) orange — 6 (DSR) 2 (DTR) orange — 6 (DSR)
3 (TXD) black — 3 (RXD) 3 (TXD) black — 2 (RXD)
4 (GND) red — 7 (GND) 4 (GND) red — 5 (GND)
5 (GND) green — 7 (GND) 5 (GND) green — 5 (GND)
6 (RXD) yellow — 2 (TXD) 6 (RXD) yellow — 3 (TXD)
7 (DSR) brown — 20 (DTR) 7 (DSR) brown — 4 (DTR)
8 (CTS) gray — 4 (RTS) 8 (CTS) gray — 7 (RTS)
website i find very helpful

http://www.sunhelp.org/unix-serial-port-resources/serial-pinouts/#netrat1105.link

hyperterm settings
baud 9600
data bits 8
parity none
stop bits 1
flow control none

thanks

ca

 

[zach99]

Thanks, Just what I wanted.