Hunting works but fdn does not

[hotrod7380]

I have three analog sets, CS1000E 7.5, the three sets hunt in linear so ,1 2 3 just fine. The problem is when 1st hunts to the 2nd it will not follow the fdn (VM). The cls has fna hta on all three sets with the first two set are programed to fdn to vm and the last set with both hnt and fdn going to vm. So call comes in hits 1st set, set busy hunt to 2nd set,set not busy, no answer does not go to vm, just rings. even when it hunts to the last set and no answer it just rings. System was just upgraded from 81c rls 25.15 to CS1000e rls 7.5 any thoughts

 

[GHTROUT]

I'd try CLS SFA - see it here: [URL unfurl="true"]http://www.ghtrout.com/rdr/sfa.html[/url]

Find more at GHTROUT.com

 

[hotrod7380]

Sfa is in the cls, the hunt dn and the fdn are different

 

[GHTROUT]

I guess you will need to print them out and show us. We can't tell from here.

Find more at GHTROUT.com

 

[GHTROUT]

Another thing to compare is the LD21 RDR Datablock. They might not have carried over some of these settings from your last version.

Find more at GHTROUT.com

 

[cmawbey]

look at FNAD FNAT FNAL in the RDR block, print in LD 21