jims5650
MIS
- Dec 12, 2005
- 11
- 0
- 0
I am trying to setup a simple 4 port analog module with 4 local POTS lines connected. I created a hunt group with all the extensions. Also have the incoming group ID and outgoing call group IDs set to both 0 within the lines with the local numbers. The incoming call route is set to 0 as well and the destination is Main (the hunt group). I can complete outgoing call but can't receive incoming calls.
Don't know if the red flag next to the hunt group has any bearing on this.
Any ideas would be greatly appreciated
Don't know if the red flag next to the hunt group has any bearing on this.
Any ideas would be greatly appreciated