Hunt Group Calling between networked BCM's 1

[clintf]

Just recently had 6 BCM's installed 400 at the main office and 50's at the remotes. All BCM's are networked 2100 2200 2300 2400 2500 2600 when i create hunt groups and change the DN on the hunt group from 5501 to 2290 so it can be reached over the network whenever i dial the DN it goes to the reception set instead of ringing the hunt group any ideas on how to get this to work ?

Short notes when i call one sites Hunt Group DN 2290 from a remote site always rings into the reception set which is 2200. So its getting routed to the right location just not ringing the sets.

thanks guys.

 

[DBrewsky]

In order to dial into a hunt group from an external location, it will need to be assigned a DID (target line) with Private Received Digits. Create a target line with digits the same as the hunt group, then in the hunt group assign that target line..

 

[clintf]

Great advice worked like a charm!