Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

HSCL2928 DLPAR ADD I/O resources failed error

Status
Not open for further replies.

michael1212

IS-IT--Management
Jun 14, 2005
36
ZA
When I try to add a DVD device to a LPAR on a p570, I get the following error:

HSCL2928 DLPAR ADD I/O resources failed: The I/O slot dynamic logical partitioning operation failed. Here are the I/O Slot IDs that failed and the reasons for failure:
U7877.001.DQD2AZD-P1-T15 (21020003).

The device is not allocated to another LPAR, and there is no problem when adding to the other LPARs, only this one.

Any idea?
Thanks!
 
R you sure this dvd is not assigned to another lpar?

ok if not then try to assign the dvd to another lpar and make sure that it is working then try to move the dvd from that lpar to the destination and see what happens

Regards,
Khalid
 
Yes, I removed the device from LPAR. I can assign to other LPARs without problem. Also did rebuild the Managed System.

Thanks!
 
You've double checked that the slot for the dvd drive was added to the profile of the lpar as desired (before it was powered on)?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top