After turning on the plotter E02 is displayed after the self test. The operator manual say's its a microprosser error/ROM checksum error. When I plot a drawing, it plots to one side and only half the drawing is on the page. Someone suggested I need to get new proms programmed. Any one have any suggestions.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
HP7580b plotter E02 error
- Thread starter AlexTheo
- Start date
Similar threads
- Locked
- Question
