WE BOUGHT OUR HP 4200 IN 2004, IN OCTOBER 2006 WE HAD TO BUY A NEW FUSING ASSEMBLY BECAUSE THE FIRST ONE KIND OF TORE APART IN A SPIRAL FASHION. NOW, APRIL OF 07, THE SAME THING IS HAPPENING AGAIN? IS THIS A COMMON OCCURRANCE OR DO YOU THINK SOMETHING ELSE IS CAUSING THAT ROLLER PIECE TO SPIRAL APART? NOT SURE WHAT TO DO NOW, ORDER A NEW PART OR A NEW PRINTER! THANKS!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
HP4200 FUSING ASSEMBLY
- Thread starter mustangs
- Start date
- Moderator
- #2
I haven't heard of that happening "regulary".
Are you running unusual stock through it (transparencies, etc), or could there be a piece of debris (staple, etc) that dropped down in there?
I would pull the fuser, and give it a REAL hard look for something scoring the assembly.
Just my 2¢
-There once was a man from Peru
Who wanted to write a Haiku
but...
--Greg
Are you running unusual stock through it (transparencies, etc), or could there be a piece of debris (staple, etc) that dropped down in there?
I would pull the fuser, and give it a REAL hard look for something scoring the assembly.
Just my 2¢
-There once was a man from Peru
Who wanted to write a Haiku
but...
--Greg
- Status
Similar threads
- Locked
- Question