Have an older D310 server I recently bought. Had to get a Wyse 325 terminal for the console. I can get the display to work during the bootup process, can interrupt boot and interact with ISL, but when I go to boot (either from primary boot device or from CD), the display shows the boot path, and 3 checksum (I assume) numbers, and that's it. The drives keep flashing and working for another 4-5 minutes or so, so I know the system is booting, but the console does not display anything past those three checksum numbers. Any ideas? I personally shut down the system from the guy I bought it from, so I know it works, it's just a different terminal than the one that was originally attached - yet I can still do anything within the ISL and it displays fine. Terminal emulation set to vt100.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
HP-UX (11.0) boots, but no console display
- Thread starter tmcgove
- Start date
Similar threads
- Locked
- Question