HI, My boss just got a new HP L1800 flat screen. Straight out of the box, I plugged it into a new PC; no signal. Keeping in mind that this screen has two inputs i made sure it was plugged into Input 1 and selected it with the switch. Still no signal. It turns on,(green light is on), screen flashes to a different blackness state but you still see nothing.
Ive,
- Tried it on an other PC tat has a Dell flat screen,
- Switched the resolution to the manual's recommendation
- Switched the resolution to lots less tan that
- Adjusted contrast during all that,
- Called HP tech Support, they didnt even knew they sold a flatscreen
Its like the screen wont get out of sleep mode...
Any Ideas please..
Many thanks...
STEVE
Ive,
- Tried it on an other PC tat has a Dell flat screen,
- Switched the resolution to the manual's recommendation
- Switched the resolution to lots less tan that
- Adjusted contrast during all that,
- Called HP tech Support, they didnt even knew they sold a flatscreen
Its like the screen wont get out of sleep mode...
Any Ideas please..
Many thanks...
STEVE