Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

HP DAT 8i Novell 4.11 & ArcServe 6.1 + Groupwise 5.2.5

Status
Not open for further replies.
Garth

Garth

IS-IT--Management
Mar 30, 2000
5
0
0
GB
Visit site
I have a HP Netserver LC II running OS Netware4.11 & Arcserve 6.1.&nbsp;&nbsp;When i run the diags on boot up it recognises the tape drive on SCSI ID 6 ok. Load up OS and Arcserve if i go to Tape server managemant i can run the standard and full test without any problems. I encounter a problem of time out when i have scheduled a back-up job utilising AUTOPILOT. The ArcServe system unloads the ANTI-Virus and then after 10mins loads the Anit-Virus which i suspect is causing the problem. The result is backup fails error being E0015 if i check the logs it is shown as time out !!!.<br><br>Has anyone experienced this if so please advise.<br><br>Regards <br><br>Garth
 
Status
Not open for further replies.

Similar threads

0LaoyanG0
  • Locked
  • Question
LSI 9266-8i (pulled from Cisco c220 M3) Slow performance
Replies
0
Views
38
0LaoyanG0
0LaoyanG0
VioSpeed
  • Locked
  • Question
LSI 9341-8i Slow Performance
Replies
1
Views
57
technome
technome
MoMurdoc
  • Locked
  • Question
Moving an HP D6000 to another server
Replies
0
Views
31
MoMurdoc
MoMurdoc
KubaKuba
  • Locked
  • Question
HP LeftHand P4300
Replies
0
Views
35
KubaKuba
KubaKuba
johnsmike
  • Locked
  • Question
HP ProLiant server hangs at “Power and Thermal Calibration” screen
Replies
3
Views
155
johnsmike
johnsmike

Part and Inventory Search

Sponsor

Back
Top