I have an 8100 doing something odd from tray 3 only. It frequently creases the paper about 2 inches from the leading edge. Usually the paper feeds completely through the printer but when it gets stuck, it wedges in the metal paper guide just past the transfer roller housing. HP says it may be a PIU problem. If that's the case, why does the paper make it past the input to the toner cartridge and why does it feed properly from tray 2, if the problem is the input? I replaced the feed separation rollers and the transfer roller and housing with temporary improvement. Anyone ever seen anything like this? ANY SUGGESTIONS would be appreciated!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
HP 8100
- Thread starter loeslaser
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
