HP 4033A & MX4000 / Inno 3d conflict

[johnbullas]

Seasons's Greetings

As a result of peolple getting TFT/LCDs as gifts I have inherited a nice HP 4033A 19" monitor (uses BNC outputs vi an adaptor cable to a 15 pin VGA...

The monitor works via a MX4000 (-84?) 64MB 32Bit AGP card without problems UNTIL the device is installed using the XP plug and play drivers, the AGP card has been driving a recent DELL monitor fine.

If the "Inno 3D" drivers are installed (XP drivers) to get the card fully under XPs grasp, the PC boots fine, windows starts then the screen goes black before the login box... if the same process is followed with the old DEll monitor in place the monitor displays the built in "sync out of range" wandering text message.

Any way to actually get this card to work WITH The XP driver s instead of the backup ones XP uses after I stop the autoinstall of drivers on XP startup following removal of the device via Control Panel > Hardware.

Drivers/Manual for this monitor would be most appreciated too!!!!




=========================
Transport Solutions
Southampton UK