Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to use PC-Regen? 1
- Thread starter bb34nne
- Start date
-
1
- #2
Hi,
PC-Regen is easy to use. It creates a file that you can transmit in WinFiol that gets prints of the current config. You can then use PC-Regen to create the initiate commands to rebuild the same config. The nice bit is that you can choose the release from and to e.g. BC10 to BC12.
1) Start PC-Regen... choose a site name, source & dest folders & from and to source release.
2) Choose Data Gen... Start...
3) Then in WinFiol load the DATA.CMD file. (It’s location is controlled in the settings menu...default paths... catalogue of PC-Regen)
4) Transmit the file from WinFiol (Switch off stop on errors in WinFiol press F-11)
5) In PC-Regen choose Regeneration
6) In WinFiol load the target file REGENCMD.CMD and transmit when ready.
Regards
Isinor
PC-Regen is easy to use. It creates a file that you can transmit in WinFiol that gets prints of the current config. You can then use PC-Regen to create the initiate commands to rebuild the same config. The nice bit is that you can choose the release from and to e.g. BC10 to BC12.
1) Start PC-Regen... choose a site name, source & dest folders & from and to source release.
2) Choose Data Gen... Start...
3) Then in WinFiol load the DATA.CMD file. (It’s location is controlled in the settings menu...default paths... catalogue of PC-Regen)
4) Transmit the file from WinFiol (Switch off stop on errors in WinFiol press F-11)
5) In PC-Regen choose Regeneration
6) In WinFiol load the target file REGENCMD.CMD and transmit when ready.
Regards
Isinor
- Status
Similar threads
- Locked
- Question
- Locked
- Question