How to setup an ARN to use 128k on ISDN BRI 1

[d1star]

Hi All;

I have a few Nortel ARN routers which are to use PPP demand-circuits for back-up. I want to use a 128K ISDN BRI connection for my PPP demand-circuit on the ARN, which will establish the call to either a Nortel BCN router or Cisco router. The BCN or Cisco routers will be using ISDN PRI. So far I can only get a 64K connection whenever I establish a call.
I am relatively new to ARN's and setting up ISDN on them, and would like to know if anyone can give me some pointers in setting this up or tell me where I can find technical documentation that would tell me how (Note: I have already looked through the Nortel site and have not found anything).

Thanks

 

[jonks]

you need to create a demand pool and then create a demand circuit for that pool.

you then need to create a bandwidth on demand pool and create a bandwidth on demand circit and chose 2 channels to be used for that circuit

These does work as i have had it running for the last 4 years