How to set up a T1 internet on a Secure Router?

[Skyfall]

I'm new with T1 set up and secure router as well. The situation is simple, I have these info:
P2P T1 IP address(service is up), public IP block (5 IPs), SR1001 router.

I deployed T1 IP to WAN port, 192.168.0.2 to LAN port, so what else I need to do to complete this job? The LAN user has no internet access now. Which IP address is the default gateway for SR1001 Router (should ISP give me the next hop IP)? Which IP is the default gateway for LAN PCs?

Thanks for any help.

Life is keeping learning......

 

[SharpAdam]

Greetings -
Your ISP should provide you with all the configuration details on the WAN Side.
Your LAN computers should use the 192.168.0.2 address as their default gateway.
Check to see if you can ping from the router out to the internet. telnet or console into the router and try to ping 216.45.19.33 (tek-tips.com webserver). If this doesn't work, your issue is in the router's WAN config. If this does, your issue is your LAN config.

Good luck!

 

[Skyfall]

I have to use the WAN interface IP address not the LAN interface IP 192.168.0.2 as the default gateway for all Pcs, then they can access the internet.

Life is keeping learning......

 

[curtismo]

This sound similar to the situation I have with an SR1002. My ISP provisions Internet on Frame Relay but the interface is unnumbered. The SR1002 will not do this; I have had a case with Nortel open for over a year. They promised but have not delivered.

Took an old ARN router off the shelf and was able to set up unnumbered Frame Relay in 15 minutes.