How to set a test alarm in a SigServer

[ChrisJGB]

In the Callserver you can set a test alarm (eg: LD 117 test alarm ini 000). Does anyone know how to set a test alarm in a Sigserver so that the Sigserver sends a SNMP trap to our managementdevice.

Thnx, Chris

 

[bignose21]

This is in the expert guide:

3.89 itgAlarmTest alarm
Creates and sends a dummy SNMP alarm for one or more ITGnnnn alarms. The parameter alarm is set as follows:
alarm < 0 - send dummy SNMP alarm messages for all ITS alarms
0 <= alarm < 36- send a dummy SNMP alarm message for the specified alarm
Note the current maximum alarm value is 35, subject to change in the future.
IPL> itgAlarmTest 35
value = 0 = 0x0
IPL>
FEB 16 15:58:11 tShell: Notice ITG6035 Encountered an unexepected open DSP chann
el, closed it: 11 (202)
IPL>

 

[bignose21]

That was the Release 5.0 NTP

 

[ChrisJGB]

TOP. this also works in rel 6.0. do you have a list off all the test alarms or where can i find a list of the test alarms


Chris

 

[bignose21]

It just matches the alarm described in the Software input/Output guide NTP