How to send out blank caller ID

[kwing112000]

I have IP office 403 with PAETEC PRI and do not want to send any caller ID out. I want them to see blank and they will over ride and send out my main number. Right now they see 3 digits from the ext I am dialing from.

Any help will be appreciated.

 

[big70]

Use .W to block your number in your shortcode.
Here are al caracters for shortcode,s

C – Place digits following the "C" in the outgoing call's Called Number field rather than Keypad field (this is the default).

D – Wait for connection, then send the following as DTMF. (See Using Least Cost Routes for an example). Note: A DTMF tone will not be produced if you are running IP Office 401 control unit.

E – Replace with the Extension Number dialing the Short Code.

I - Send data in an Information Packet rather than Set-up Packet (for advance use).

K - Place the digits following the "K" in the outgoing call's Keypad field rather than Called Number field. Only supported on ISDN/QSIG.

L - Use the last number dialed.

N - Substitute with digits dialed for N or the string of "X"s in the Short Code field. For example use the Hunt Group extension number entered as part of the short code. (See default short code *20*N# for an example.)

S - Place the digits following the "S" into the outgoing call's Calling Number field. See Short Code Examples .

SS - Pass through the Calling Party Number on VPN lines. For example, to provide the incoming ICLID at the far end of a VoIP connection, a short code ? with telephone number .SS should be added to the line.

t - Set the maximum duration for a call (+/-1 minute). Follow the Telephone Number entry of short codes using a dial feature with t(x) where x is the number of minutes. See Maximum Call Length.

U - Replace with the User Name of the User dialing the Short Code. See default short code *17 for an example.

W – Set flag in packet to withhold outgoing Caller ID (operation is PSTN network dependent.

@ – Enter following digits into sub-address.

. – Replace with current dialed digits, ie. those that have been dialed so far and triggered the short code match.

, – One second pause in between DTMF digit dialing (See Using Least Cost Routes for an example).

" " – Any text must be surrounded by quotation marks, eg. User or Hunt Group Names.

? – In conjunction with the Voicemail Collect feature. Indicates collect messages.

# – In conjunction with the Voicemail Collect feature. Indicates leave messages.