Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to run pre and post scripts 1
- Thread starter mturnali
- Start date
-
1
- #2
There are pre and post script possiblities with Legato. There is a special command called savepnpc. It allows for both pre and post processing. See the command page on its use. It runs the pre and post commands one time with a save in between. You apply the savepnpc in the client resource in the "Backup command" field.
You can also just write a script and include your save and mminfo commands and have Legato use it by applying the script you write in the client resource in the "Backup command" field. But this script will run once for every save set in the client.
Good luck.
You can also just write a script and include your save and mminfo commands and have Legato use it by applying the script you write in the client resource in the "Backup command" field. But this script will run once for every save set in the client.
Good luck.
- Status
Similar threads
- Locked
- Question