Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to Reset a Compact 6x16 to defalt values
- Thread starter PBXKID2
- Start date
You should post in the NORSTAR thread, but here you go.Performing Startup
1. Enter the Startup access code from a Norstar M7310 or M7324 telephone dial pad by pressing f**startup¸ which is the same as f**7827887.
To be accepted, the Startup code must be entered no later than 15 minutes after the Norstar system has been powered up. (If 15 minutes have elapsed since you powered up the system, turn system power off and on to prepare for the Startup process.)
2. Enter the Installer password. The default is config which is the same as f**266344.
Tip - The Installer password shown is the default normally used for Startup. For a system which has already been programmed, the Installer password might have been changed in programming and recorded in the Programming Record.
Good Luck!!
1. Enter the Startup access code from a Norstar M7310 or M7324 telephone dial pad by pressing f**startup¸ which is the same as f**7827887.
To be accepted, the Startup code must be entered no later than 15 minutes after the Norstar system has been powered up. (If 15 minutes have elapsed since you powered up the system, turn system power off and on to prepare for the Startup process.)
2. Enter the Installer password. The default is config which is the same as f**266344.
Tip - The Installer password shown is the default normally used for Startup. For a system which has already been programmed, the Installer password might have been changed in programming and recorded in the Programming Record.
Good Luck!!
- Status
Similar threads
- Locked
- Question
- Locked
- Question